Timers

Technical Specifications

Installation

Program Manual

Warranty

If you don't have Acrobat Reader, it is available
free from Adobe using the link below.

Get Acrobat Reader

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 


Leaders in Water Treatment Control Equipment
ST & DT Series

Technical Specifications

Installation

Warranty

If you don't have Acrobat Reader, it is available
free from Adobe using the link below.

Get Acrobat Reader

Carlon Meter Hot Water Turbine Carlon Programmable Timer Controls have wide applications. Timers control the length of the signal needed to operate chemical feed pumps, valves or other equipment long enough to perform the operation needed in the water treatment system. Typical Timer systems use the pulse signal from a JSJ Series Electric Contacting Meter, to activate the Timer(s) in the control cabinet. The Timer(s) sends a timed output signal (adjustable) to a chemical feed pump, solenoid valve or water softener as determined for the application.

Offering These Advantages

Chemical feed in direct proportion to water used Reliable solid state circuitry
Automatic compensation for variations in water flow User choices for sequencing and timing units needed
Easy adjustment of the desired length of the timer output signal

Specifications

Dry Contact normally open switch closure activates timer(s).

Display: LCD Display
Input Power: 120 Volt, 60 Cycle
Output Signal:
120 Volt, 60 Cycle, 3 Amp Maximum
Counting Speed: 1 to 999 Seconds or Minutes
Memory: 40 Years, EEPROM

PTC Series - Controller Selection Chart

Model Description Weight Height Width Depth
PTC2001 Single Timer 2.0 LBS 3 1/2" 5" 5"
PTC2002 Dual Timer 2.1 LBS 3 1/2" 5" 5"
PTC2003 Triple Timer 2.4 LBS 3 1/2" 5" 7"
PTC2004 Quadruple Timer 2.5 LBS 3 1/2" 5" 7"



Meter Mounted Timer Controls - ST & DT Series
Carlon Mounted Meter/Timer Systems offer the most complete, economical and convenient system available for controlling chemical metering pumps, valves or other equipment. Installation is easy! Just install the meter, plug in the 120 volt power cord, and plug the unit to be controlled into the receptacle on the timer. The meter is pre-wired to the Timer Control. This Control is also available with two timers in our DT Dual/Timer System for controlling two units at one time.

Offering These Advantages

Carlon Electric Contacting JSJ Series Water Meter
Carlon Lower Cost Timer
Standard Dual Receptacle for pump, valve or other units
Total Output Rating for up to 15 AMP resistive @ 120 V
Timer Setting available in seconds or minute increments
Meter is Pre-wired to the Timer Control

ST & DT Series

ST - Single Timer
Model Number
DT - Dual Timer
Model Number
Meter Size
JSJ062ST JSJ062DT 5/8" X 1/2"
JSJ0621ST JSJ061DT 5/8" X 3/4"
JSJ075ST JSJ075DT 3/4" X 3/4"
JSJ100ST JSJ100DT 1" X 1"
JSJ150ST JSJ150DT 1 1/2"
JSJ200ST JSJ200DT 2"