You are here: Home / Products / Industrial Meters/Controls / Controls / Timer Controls

Timer Controls

Timers

Product Specifications

Installation

Program Manual

Warranty

If you don’t have Acrobat Reader, it is available free from Adobe using the link below.

Get Acrobat Reader
Leaders in Water Treatment Control Equipment

Timer ControlCarlon Programmable Timer Controls have wide applications. Timers control the length of the signal needed to operate chemical feed pumps, valves or other equipment long enough to perform the operation needed in the water treatment system. Typical Timer systems use the pulse signal from a JSJ Series Electric Contacting Meter, to activate the Timer(s) in the control cabinet. The Timer(s) sends a timed output signal (adjustable) to a chemical feed pump, solenoid valve or water softener as determined for the application.

Offering These Advantages

  • Chemical feed in direct proportion to water used
  • Automatic compensation for variations in water flow
  • Easy adjustment of the desired length of the timer output signal
  • Reliable solid state circuitry
  • User choices for sequencing and timing units needed

Specifications

  • Dry Contact normally open switch closure activates timer(s).

Product Details

Display: LCD Display
Input Power: 120 Volt, 60 Cycle
Output Signal: 120 Volt, 60 Cycle, 3 Amp Maximum
Counting Speed: 1 to 999 Seconds or Minutes
Memory: 40 Years, EEPROM

PTC Series – Controller Selection Chart

Model Description Weight Height Width Depth
PTC2001 Single Timer 2.0 LBS 3 1/2″ 5″ 5″
PTC2002 Dual Timer 2.1 LBS 3 1/2″ 5″ 5″
PTC2003 Triple Timer 2.4 LBS 3 1/2″ 5″ 7″
PTC2004 Quadruple Timer 2.5 LBS 3 1/2″ 5″ 7″
ST & DT Series

Product Specifications

Installation

Warranty

If you don’t have Acrobat Reader, it is available free from Adobe using the link below.

Get Acrobat Reader
Leaders in Water Treatment Control Equipment

Meter Mounted Timer Controls – ST & DT Series

DT & ST Timer ControlCarlon Mounted Meter/Timer Systems offer the most complete, economical and convenient system available for controlling chemical metering pumps, valves or other equipment. Installation is easy! Just install the meter, plug in the 120 volt power cord, and plug the unit to be controlled into the receptacle on the timer. The meter is pre-wired to the Timer Control. This Control is also available with two timers in our DT Dual/Timer System for controlling two units at one time.

Offering These Advantages

  • Carlon Electric Contacting JSJ Series Water Meter
  • Carlon Lower Cost Timer
  • Standard Dual Receptacle for pump, valve or other units
  • Total Output Rating for up to 15 AMP resistive @ 120 V
  • Timer Setting available in seconds or minute increments
  • Meter is Pre-wired to the Timer Control

ST & DT Series

Display: LCD Display
Input Power: 120 Volt, 60 Cycle
Output Signal: 120 Volt, 60 Cycle, 3 Amp Maximum
Counting Speed: 1 to 999 Seconds or Minutes
Memory: 40 Years, EEPROM

PTC Series – Controller Selection Chart

ST – Single Timer
Model Number 		DT – Dual Timer
Model Number 		Meter Size
JSJ062ST JSJ062DT 5/8″ X 1/2″
JSJ0621ST JSJ061DT 5/8″ X 3/4″
JSJ075ST JSJ075DT 3/4″ X 3/4″
JSJ100ST JSJ100DT 1″ X 1″
JSJ150ST JSJ150DT 1 1/2″
JSJ200ST JSJ200DT 2″